MiFab logo

Serving all of the USA, Canada, Australia and the Middle East, MIFAB can provide you with the quality, engineered plumbing and drainage solutions you need. Innovative product designs save the installer time and material cost and provides the owner with higher quality cast stainless steel drains and cleanouts for the same cost as the industry standard nickel bronze. Contact us today to learn more.

All Categories  > Interceptors  > MI-CSD Series - For MI-G-SD(H) Series Draw-off Grease Interceptors
MI-CSD Series - For MI-G-SD(H) Series Draw-off Grease Interceptors

Click for specsheet

Click for downloads

List Prices

 

MIFAB Series MI-CSD 7-75 sanitary powder epoxy coated inside and outside fabricated 10 gauge steel cover shroud.

Unit to include: angle support brackets on outside to anchor shroud into underground and inside to support the MIFAB Series MI-G-SD(H) grease interceptor furnished (specify MI-G-SD or MI-G-SDH grease interceptor required), removable steel powder epoxy coated, non skid rectangular gasketed lid with two recessed pull ring handles, and holes on each side of shroud for adjustment of angle support brackets.

MI-CS Series supplied with one interior & one exterior angle support bracket per side. Interior angle bracket to support interceptor (purchased separately), exterior angle bracket to form anchor flange.

Specifications
No. of Lids

Note
Item Name

Series

MI-CSD Series for MI-G-SD(H) Series Draw-off Grease Interceptors

MIFAB Design
Maintenance & General Considerations
To obtain optimum operating efficiency of a properly sized and installed PDI certified grease interceptor, a regular schedule of maintenance must be adhered to. All PDI certified grease interceptors are furnished with manufacturer's operating and maintenance instructions, which must be followed to insure efficient satisfactory operation.
Sizing
Fixture Unit Sizing Method
Capacity

Disposition of Intercepted Materials
Grease and other waste matter that has been removed from the interceptor should not be introduced into any drain, sewer, or natural body of water. This waste matter should be placed in proper containers for disposal. Where recovery of grease is desired, it can be handled in a manner suitable to the authorities.
Grease Interceptors
Gallons Per Minute [Flow Rate]

Cleaning
All grease interceptors must be cleaned regularly. The frequency of grease removal is dependent upon the capacity of the interceptor and the quantity of grease in the waste water. Grease removal intervals may therefore vary from once a week to once in several weeks. When the grease removal interval has been determined for a specific installation, regular cleaning at that interval is necessary to maintain the rated efficiency of the interceptor. After the accumulated grease and waste material has been removed, the interceptor should be thoroughly checked to make certain that inlet, outlet and air relief ports are clear of obstructions.
Dimensional Drawing
File Not Found
Dimension F
Dimension E
Dimension D
Dimension C

No. of Bolts

Operation
Dimension B
MIFAB, Inc.
1321 West 119th Street Chicago, IL 60643
Toll Free: 800.465.2736
Tel: 773.341.3030
Fax: 773.341.3047
E-mail: sales@mifab.com